Year 3 Week 1 – 28/09/26

Written by

in

“There’s 104 days of summer vacation, and school comes along just to end it” – Phineas and Ferb

I was worried that my summer was an unproductive one, but after reflecting on it I have changed my mind.

I have greatly improved my soldering skills. I wanted to learn how modchips are installed, and it takes microsoldering to a whole new level. The pads were genuinely the size of a crumb, as seen in Figures 1 and 2, I could not see them without a microscope. I got stuck for weeks, being unable to get the solder to flow, and ended up doing a lot of research into the science behind soldering which helped me understand why it wasn’t working before.

The most important part of soldering is the heat transfer, that’s what causes the chemical reaction we call soldering. With smaller solder pads used in microsoldering I need smaller iron tips for better precision, but smaller tips don’t get as hot. Turning up the iron does help, but it also causes the tip to oxidize quicker, and a dirty tip ALSO affects heat transfer.

I only have one tip small enough to install modchips with, so I also got a lot of practice cleaning them with copper wool. I used a sponge at first, but I found that those significantly cool down smaller tips which is not helpful. I got very good at using the wool, I can pretty much see my reflection in my iron tip.

I want to do a lot of soldering this year, I am excited to put my practice to use!

Figure 1: Modchip solder points under a microscope
Figure 2: The same solderpoints seen in Fig. 1 next to my finger

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *