Year 3 Week 4 – 19/10/26

Written by

in

“Keep moving forward!” – Wilbur Robinson, Meet The Robinsons

One of the first things I learned to repair was iPods. I really hate Spotify, they underplay artists and incorporate generative AI into their platform, so when I learned people were digging up old iPods and fixing them I immediately hopped onto the trend.

My friend Ava asked me if I would fix her old 4th gen iPod shuffle yesterday, seen in Fig. 1, and I happily agreed to do so. This made me reflect on the first iPod I fixed as it was also a 4th gen. Companies such as Apple often use parts that are easy to break, such as screws made of weak metals that strip easily, to deter people from fixing them at home. With the 4th gen shuffles I found that as soon as I tried to solder in a new battery the ribbon cable housing melted (seen in Fig. 3)! It had only been a few seconds but the board was ruined instantly. I am much more careful nowadays, using a lower temperature on my iron and kapton tape to protect the plastic.

The batteries use through-hole soldering, which makes it even more difficult to replace them. I often get a friend to hold the board for me while I do it, and I need a microscope to see where the holes are. As seen in Fig. 2, they are extremely small.

Ava’s iPod is working perfectly with the new battery and I’ll give it to her in Thursday!

Figure 1: Ava’s 4th Gen iPod Shuffle and replacvement battery with a pound coin for scale
Figure 2: iPod battery solder points next to pound coin for scale
Figure 3: iPod 4th gen shuffle board I Melted with a soldering iron

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *